Drain Hose Connection - ETNA VWV549WIT Mode D'emploi

INSTALLATION

Drain hose connection

Leveling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or
out) to adjust the height of the dishwasher, making it level. In any case,
the appliance should not be inclined more than 2º.
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm,
or let it run into the sink, making sure to avoid bending or crimping it.
Use the special plastic support that comes with the appliance. The free
end of the hose must be at a height between 40 and 100 cm and must
not be immersed in water.
If the height of the sink is more than 100 cm, the water can not be
drained through the sink. In that case the drain hose must be placed in
a suitable bowl or bin which is lower than the sink.
Attention!
Close the water tap after use!
ø 40 mm
ø 40 mm
EN 23