Cleaning The Spray Arms; Cleaning The Door - ETNA VWV549WIT Mode D'emploi

MAINTENANCE

Cleaning the spray arms

It is essential that you clean the spray arms on a regular basis. In the longer term, waste can
block the nozzles and the bearings in the spray arms. Clean the spray arms as follows:

Cleaning the door

Clean the edge of the door, including the sealing rubber, with a soft, damp cloth. Take care to
ensure that water does not enter the door locking mechanism or electrical components. Spray-
type cleaning products should not be used, nor aggressive cleaning products such as scourers.
These cleaning products can damage the finish.
EN 18
• To remove the upper sprayarm, hold the nut , rotate the arm
clockwise to remove it. To remove the lower spray arm, pull out the
spray arm upward.
• Clean the spray arms in warm, soapy water, using a soft brush to
clean the nozzles.
• Rinse the spray arms thoroughly before fixing back in place.