Cleaning The Spray Arms; Cleaning The Door - ETNA VW339M Mode D'emploi

MAINTENANCE

Cleaning the spray arms

Cleaning the door

EN 20
3
• Make sure that the spray holes are not clogged and that no food
waste is stuck to the spray arms.
• If there is any clogging, remove the spray arms and clean them
under water.
• To remove the upper spray arm undo the nut holding it in position
by turning it clockwise and pulling it downwards.
• Make sure that the nut is properly tightened when refitting the upper
4
spray arm.
• Clean the edge of the door, including the sealing rubber, with a soft,
damp cloth.
• Take care to ensure that water does not enter the door locking
mechanism or electrical components.
• Spray-type cleaning products should not be used, nor aggressive
cleaning products such as scourers.
• These cleaning products can damage the finish.