Dishwasher Detergents - ETNA VW339M Mode D'emploi

OPERATION

Dishwasher detergents

Filling the rinse aid and setting
To fill the rinse aid compartment, open the rinse aid compartment cap.
Fill the compartment with rinse aid to the MAX level and then close the
cap.
Be careful not to overfill the rinse aid compartment and wipe up any
spills.
In order to change the rinse aid level, follow the below steps
before turning on the machine:
1. Push the programme button and hold it down.
2. Turn on the machine.
3. Hold down the programme button until all leds blink twice.
▷ Rinse aid set follows water hardness set.
▷ The machine will display the current setting.
4. Set the level by pushing the programme button.
5. Switch off the machine to save the setting.
The factory setting is "4".
• If the dishes are not drying properly or are spotted, increase the
level. If blue stains form on your dishes, decrease the level.
Level
Brightener Dose
1
Rinse-aid not dispensed
2
1 dose is dispensed
3
2 doses are dispensed
4
3 doses dispensed
5
4 doses dispensed
The chemicals in the dishwasher detergents remove the dirt, break it
down and make sure that the dirt is drained from the dishwasher. Most
dishwasher detergents available in stores are suitable for this purpose.
Warning!
Dishwasher detergent is a corrosive product. It should therefore be kept
out of the reach of children. If swallowed, consult a doctor immediately
and take the packaging with you.
Indicator
r1 is shown on the display
r2 is shown on the display
r3 is shown on the display
r4 is shown on the display
r5 is shown on the display
EN 13