Error Codes - ETNA VW339M Mode D'emploi

ERRORS

Error codes

Problem Potential causes
FF Insufficient water supply
F5 Pressure system failure
F3 Flooding safety enabled
F2 The dishwasher is not pumping out
F8 Heating error
F1 Flooding sound signal activated
FE Interference in the electronics
F7 Temperature in the machine is too high
F9 Interference of divisor position
F6 Interference of heating sensor
HI High voltage failure
LO Low voltage failure
Solution
• Make sure that the water faucet is completely open and that there
is no crack in the supply hose
• Check if the supply hose is clogged
• Restart the dishwasher
• Please contact the service department if the problem persists
• Please contact the service department
• Close the water faucet and contact the service department
• Check if the drainage hose is connected
• Check the bottom filter and filter group
• Restart the dishwasher and terminate the last selected program
• Please contact the service department if the problem persists
• Please contact the service department
• Turn off the dishwasher and close the water faucet
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
Call an authorised service if the problem still persists after the
controls or in case of any malfunction not described above.
EN 23