Use Of Dishwasher Salt - ETNA AFI8525ZT Notice D'utilisation

Water hardness
°dH
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light. Wait until pro-
gramme light B goes off. The programme

Use of dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
°TH mmol/l
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
Adjusting the water hardness setting
manually
2
2
1
1
1
1
light A goes on flashing and simultane-
ously the End indicator light starts flash-
ing. Wait until programme light B goes off.
the programme light A goes on flashing
and simultaneously the End indicator
light starts flashing. This indicates that
you have activated the electronic setting
function of the water softener. The cur-
rent level is indicated by the number of
flashes of the End indicator light and a
pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
3. To change the level, press the pro-
gramme selection/cancel button. Each
time the button is pressed the level
changes. (For the selection of the new
level see the chart).
Examples:
if the current level is 5, by pressing pro-
gramme selection/cancel button once,
level 6 is selected,
if the current level is 10, by pressing pro-
gramme selection/cancel button once,
level 1 is selected.
4. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
To fill:
1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.
Use of
electronically
level 6
level 5
level 4
level 3
level 2
level 1
27
salt
yes
yes
yes
yes
yes
no