Cleaning The Spray Arms; Cleaning The Door - ETNA VW247M Mode D'emploi

MAINTENANCE

Cleaning the spray arms

Cleaning the door

It is essential that you clean the spray arms on a regular basis. In the
longer term, waste can block the nozzles and the bearings in the spray
arms. Clean the spray arms as follows:
• Turn the nut of the upper spray arm to the left to remove the arm.
• Next remove the spray arm.
• Pull the lower spray arm upward out of the retainer.
• Clean the spray arms in warm, soapy water, using a soft brush
to clean the nozzles.
• Rinse the spray arms thoroughly before fixing back in place.
Clean the edge of the door, including the sealing rubber, with a soft,
damp cloth. Take care to ensure that water does not enter the door
locking mechanism or electrical components. Spray-type cleaning
products should not be used, nor aggressive cleaning products such as
scourers. These cleaning products can damage the finish.
EN 21