ETNA VW247M Mode D'emploi page 77

OPERATION
Filling the rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid compartment cap.
Fill the compartment with rinse aid to the MAX level and then close the
cap.
Be careful not to overfill the rinse aid compartment and wipe up any
spills.
In order to change the rinse aid level, follow the below steps
before turning on the machine:
1. Push the programme button and hold it down.
2. Turn on the machine.
3. Hold down the programme button until "rA" disappears from the
display.
▷ Rinse aid set follows water hardness set.
▷ The machine will display the current setting.
4. Set the level by pushing the programme button.
5. Switch off the machine to save the setting.
The factory setting is "4".
• If the dishes are not drying properly or are spotted, increase the
level. If blue stains form on your dishes, decrease the level.
Level
Brightener Dose
1
Rinse-aid not dispensed
2
1 dose is dispensed
3
2 doses are dispensed
4
3 doses dispensed
5
4 doses dispensed
Indicator
r1
r2
r3
r4
r5
EN 13