Reset; Setting The Water Hardness; Rinse Aid Reservoir - ETNA VW247M Mode D'emploi

OPERATION

Reset

Setting the water hardness

Rinse aid reservoir

EN 12
Open the door of the dishwasher
The indicator of the program selected last is flashing.
Press and hold the programming button for more than 3 seconds.
The 'End Program' indicator is flashing. The indicator of the program
selected last turns off
Close the door of the dishwasher.
The machine pumps out for about 30 seconds. Following the end of
this, a sound signal will click 5 times and the indicator shows that the
program has finished.
Switch off the dishwasher with the on/off button.
Press the program button and keep it pressed.
Switch on the dishwasher simultaneously with the on/off button.
Keep the program selection button pressed until "SL" disappears from
the display. Release the program selection button after "SL" disappears
from the display.
Your machine displays the latest entered water hardness setting.
Water hardness can be adjusted by the program selection button
according to Table of Water Hardness Level Settings.
After selecting the desired setting, press the on/off button.
The set value is stored in the memory.
Rinse aid is added during the final rinse. Rinse aid prevents traces of water
droplets being left behind on the clean dishes. Moreover, it ensures that the
dishes dry quicker, since the water drains off more easily.
The dishwasher is designed for use with liquid rinse aid. The rinse aid
reservoir is located on the inside of the door, alongside the detergent
compartment.