First Use; Setting The Water Softener - ETNA VWV549WIT Mode D'emploi

FIRST USE

Before using the dishwasher for the first time:
• Set the water hardness.
• Add 1 litre of water to the salt reservoir and then add 1.5 kg of dishwasher salt.
• Add rinse agent.
• Add detergent.

Setting the water softener

1. Open the door.
2. Press the "on/off" button to switch on the appliance.
3. Press the Rapid program button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on (the water softener and Rinse
agent warning lights will be on periodically when it get in the set model ).
4. Press the Rapid program button to select the proper set according to your local
environment, the sets will change in the following sequence: H1->H2->H3->H4->H5->H6 /
see water softener table.
5. Press the "on/off" button to end the set up model.
Water softener table
ºClarke
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
The manufactory setting: H3 (EN 50242)
Your local water authority can inform you how hard your mains water is.
EN 6
Water hardness
ºdH mmol/l
0 - 5 0 - 0,94
6 - 11 1,0 - 2,0
12 - 17 2,1 - 3,0
18 - 22 3,1 - 4,0
23 - 34 4,1 - 6,0
35 - 55 6,1 - 9,8
Selector Position
H1 (Soak)
H2 (Quick)
H3 (Soak + Quick)
H4 (ECO)
H5 (ECO + Soak)
H6 (ECO + Quick)
Salt
consumption
(grams/cycle)
0
9
12
20
30
60