Switching On - ETNA TI8022RVS Mode D'emploi

OPERATION

Switching on

EN 8
7 6
• Press the 'on/off' button (2) again to switch on the appliance.
The indicator (1) will light up when the machine is switched on.
• Select the desired cycle (see page 10 'cycle selection table). Select a
cycle using the programming button (4). The display (7) will display the
selected programme.
• Press the 'Start/Pause' button (3). The dishwasher will automatically
start running the selected cycle. In the display, the time remaining for
the program to finish its cycle is displayed.
Delayed start
If you want the dishwasher to switch on at a later time, you can used the
"delayed start" button (6). You can choose to delay the start time by 3, 6,
9 or 12 hours. Each press of the button (6) changes the delay time. The
display (7) shows the delayed start time that has been selected.
Selecting a half load
The dishwasher with Half Load Washing Function adapt to your needs, so
you can save energy consumption, water consumption as well as cycle
duration by loading dishes of half capacity anywhere you prefer.
1 2
5
Pro g. Start/Pa use Aa n /ui t
4 3 2 1