Switching On - ETNA TFI7005ZT Mode D'emploi

OPERATION

Switching on

GB 8
1 2 3 4
• Open the door to the dishwasher.
• Press the "on/off" button (8) to switch on the appliance.
The indicator (9) will light up when the machine is switched on.
• Select the desired cycle (see page 10 "cycle selection table"). Press the
programming button (7) repeatedly to select the required cycle. When
you select a wash cycle, the corresponding indicator (2) will light up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start
If you want the dishwasher to switch on at a later time, you can used the
"delayed start" button (5). You can choose to delay the start time by 3, 6,
9 or 12 hours. Each press of the button (5) changes the delay time. The
indicators (1) show the delayed start time that has been selected.
Selecting a half load
The dishwasher with Half Load Washing Function adapt to your needs, so
you can save energy consumption, water consumption as well as cycle
duration by loading dishes of half capacity anywhere you prefer.
Selecting the "3-in-1" function
The dishwasher features a 3-in-1 function. If you select this function
(button 6), the dishwasher does not need to be filled with salt and rinse
agent, but rather you use so-called 3-in-1 dishwasher tablets in their place.
This function only applies to 3 cycles: Intensive/Normal/ECO
Note: Only use 3-in-1 tablets in combination with the 3-in-1 wash function.
If you use 3-in-1 tablets with other functions, this will deliver lower
performance in terms of the washing results.
5 6 7 8 9