Switching On - ETNA AFI8029ZT/E01 Mode D'emploi

OPERATION

Switching on

GB 8
• Open the door to the dishwasher.
• Press the "on/off" button (9) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 10 "cycle selection table").
Press the programming button (7) repeatedly to select the required
cycle. The indicator (6) corresponding to the selected cycle will light up.
With the 'Plus' button (3) an extra drying program can be selected. The
'extra drying' indicator (4) will light up when this function is selected.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (1). You can choose to delay the start time by
1 to 24 hours. Each press of the button changes the delay time.
The display (2) show the delayed start time that has been selected.
Select half load
The dishwasher with Half Load Washing Function adapt to your needs,
so you can save energy consumption, water consumption as well as
cycle duration by loading dishes of half capacity anywhere you prefer.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button (7) for more
than 3 seconds. You can now re-select the desired cycle (see page 10
"cycle selection table"). Now close the door.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Detergent
compartment).
E CO