Hitachi C 8FSE Instructions De Sécurité Et Mode D'emploi page 24

English
CAUTION:
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT
EDGE against the crown molding Stoppers as shown in Fig. 40-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
Refer to the lower table for the miter angle.
For inside corner
For outside corner
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 41 by adjusting the 6mm depth adjustment
bolt.
Cutting depth adjustment procedure:
(1) Lower the motor head, and turn the 6 mm depth adjustment bolt by hand. (Where the head of the 6
mm depth adjustment bolt contacts the hinge.)
(2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of
the base (see b in Fig. 41).
(3) The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion
with a chisel.
12. Using the Light (Only Model C8FSHE)
WARNING:
24
Always confirm that the motor head (see Fig. 1) does not contact the crown molding
vise ass'y when it is lowered for cutting. If there is any danger that it may do so,
loosen the 6mm knob bolt and move the crown molding vise ass'y to a position
where it will not contact the saw blade.
Position in Fig. 34
1
2
3
4
Cut grooves with saw blade
a
b
Fig. 41
Check to ascertain that the main unit and light are off before plugging the cord into
the power socket.
The light lens reaches high temperatures during and immediately after use and should
not be touched under any circumstances.
Failure to observe this may result in burns.
Miter angle
Right 45° Save the right side of blade
Save the left side of blade
Left 45°
Save the right side of blade
Right 45° Save the left side of blade
6mm Depth
Turn
adjustment bolt
Hinge
Fig. 42
Finished piece