Hitachi C 8FSE Instructions De Sécurité Et Mode D'emploi page 14

English
8mm Depth
adjustment bolt
Hinge
Fig. 10-a
Hinge
Fig. 10-b
3. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 2-9/16" (65mm) in height in right-angle cutting or
1-25/32"(45mm) in left bevel angle cutting or 2-3/8" (60mm) in right bevel angle cutting,
adjust the lower limit position so that the base of the motor head (see Fig. 10-a) will not come
in contact with the workpiece.
6mm Depth
adjustment bolt
Turn
Hinge
Fig. 11
4. Confirmation for use of sub fence
WARNING:
Turn
Left bevel
angle cutting
Sub Fence
Fence (B)
Fig. 12
14
(1) Turn the 8 mm depth adjustment bolt, change the height where
the bolt head and the hinge contacts, and adjust the lower limit
position of the saw blade.
Gear case
NOTE:
Saw blade
Turntable
8mm Depth
adjustment bolt
Turn
Gear case
To adjust the lower limit position of the saw blade, follow the
procedure (1) shown in Fig. 11.
(1) Lower the motor head, and turn the 6 mm depth adjustment
bolt and make adjustments so that there can be a clearance of
5/64" to 1/8" (2 mm to 3 mm) between the lower limit position
of the motor head and the top of the workpiece at the saw
blade's lower limit position where the head of the 6 mm depth
adjustment bolt contacts the hinge.
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
This power tool is Equipped with a sub fence.
Right bevel
angle cutting
In the case of right angle cutting and right bevel angle cutting, use
Right
the sub fence. Then, you can realize stable cutting of the material
angle cutting
with a wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated
in Fig. 12 and then turn it counterclockwise.
Confirm that the saw blade is adjusted so that it will
not cut into the turntable.