Wilo Stratos Série Notice De Montage Et De Mise En Service page 42

ENGLISH
If the pump display is operated further, the following menus appear in succession: (horizontal representation of
display)
Single-pump mode: Setting when first used / Menu order during standard use
LC display
1
2
If no setting is made in the subsequent menus for 30s, the basic setting
3
36
After switching on the module, all symbols appear on the display for 2
seconds. The current setting
Current (basic) setting (factory setting):
f
auto
not visible
f
e.G. H 5,0 m
f
The differential pressure set point can be altered
by turning the tuning button. The new differential pres-
sure set point blinks.
The new setting is stored by pressing the button briefly.
If no button is pressed, the previously set blinking diffe-
rential pressure set point returns to the previous value af-
ter 30 s.
Press tuning button for > 1 s.
The next menu point
Position setting of display vertical / horizontal
The set position of the display is shown by the flashing "ON".
By turning the tuning button the other position can be
selected.
Setting stored.
Setting
w
then engages.
automatic night setback enabled
Pump runs in standard mode
f
Single pump
present differential pressure setpoint
Hs = 5,0 m at same time | H
(factory setting depending on pump type)
Control system p-v
e
appears..
w
re-appears in the display..
max