Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL Manuel De L'utilisateur

SPECIFICATIONS
Cat. No. ..................................................... 2818-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
No Load RPM ....................................................650
Cable Sizes ............................................5/8" & 7/8"
Recommended Pipe Diameter ..................1-1/4"-6"
Recommended Ambient
Operating Temperature .................... 0°F to 125°F

FUNCTIONAL DESCRIPTION

1
12
2
5
11
10
1. Lever arm
2. Lever arm hook
3. Lever latch/cable size selector
4. Rear guide hose connection
5. Carry strap connection point
6. Pin key holder
7. Front collar
8. Cable hook
9. Drainage port
10. Battery compartment
11. Forward/Off/Reverse
12. ONE-KEY™ indicator
13. Guide hose (not shown)
14. Carry strap (not shown)
2
3
4
5
7
8
9
Volts
Direct Current
No-Load Revolutions per Minute (RPM)
Read operator's manual.
Always wear leather gloves over
latex/rubber gloves.
Wear eye protection.
Do not allow battery to contact
corrosive or conductive fluid.
o
Forward/OFF/Reverse
UL Listing for Canada and U.S.
C US
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, unlatch the battery door, push
in the release buttons and pull the battery pack away
from the tool. Close and relatch the battery door.
WARNING
6
ries.
To insert the battery, unlatch the battery door and slide
the pack into the body of the tool. Make sure it latches
securely into place. Close and relatch the battery door.
WARNING
may be hazardous.
Selecting the Proper Cable
Different size and types of cables are available for
different applications. Remove the protective tip
cover from new cables before use.
Cat. No.
48-53-2680 5/8" X 7-1/2' All-Purpose Open Wind
Sectional Cable
48-53-2852 7/8" x 15' All-Purpose Open Wind
Sectional Cable
CAUTION
diameter pipes.
Cable Attachment Installation
To install the attachment:
Snap the attachment coupler into the cable coupler.
Test the cable before inserting into the drain to make
sure the attachment does not fall off during use.
To remove the attachment:
Insert the pin key into the coupling hole and pull at-
tachment off of cable.
4
SYMBOLOGY
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accesso-
Only use accessories specifically
recommended for this tool. Others
Description
To prevent damage to the cable and
attachments, do not use in larger