Connections - Panasonic Aquarea Air U.M. Manuel D'installation

U I S
5.3

Connections

The choice and sizing of the hydraulic lines must be made
by an expert who must operate according to the rules of
good technique and the laws in force.
To make the connections:
- position the hydraulic lines
- tighten the connections using the "spanner and
counter spanner" method
- check for any leaks of liquid
- coat the connections with insulating material
A hydraulic lines
B spanner and counter spanner
B
3-WAY VALVE WITH THERMO-ELECTRIC HEAD DIVERTER VALVE KIT
The hydraulic lines and joints must be thermally insulated.
Avoid partially insulating the pipes.
Do not over-tighten to avoid damaging the insulation.
The valve and the lockshield provide 3/4" Eurokonus
connections. Accompanying this unit there are two
adapters to transform the 3⁄4" Eurokonus connections
in 3⁄4" BSP. In this case use hemp and green paste or
similar to seal the threaded connections; the use of Teflon
is advised when there is anti-freeze in the hydraulic circuit.
C coat the connections with insulating material
D adapters
C
A
D
EN
21