Machine Onboard Control Assembly; Mounting - Panasonic Aquarea Air U.M. Manuel D'installation

MACHINE ONBOARD CONTROL ASSEMBLY AND CONNECTING
MACHINE ONBOARD CONTROL ASSEMBLY AND CONNECTING
The on-board machine control with speed selector and ON/
OFF button, thermostat adjustable between 5 and 40°C,
summer/winter selector and minimum winter temperature
4.1

Mounting

Place the control panel into its housing in the upper part of
the cooler-convector/cooler-radiator and fix it with the two
supplied screws (ref. A).
To install the connection box:
- open the box (ref. B);
- insert the lower lug into the special slot (ref. C) on the
side of the appliance;
- hook the upper part of the box to the side (ref. D);
- fix it with the two supplied screws (ref. E);
- fix the earth wire to the cooler-convector/cooler-radiator
structure using the supplied screws (the minimum force
of about 2N must be used when screwing-up);
- connect the rapid connector on the motor (FAN_COIL)
to that on the board (ref. I) *;
- connect the water probe connector (ref. F) on the
A
C
14
D
E
(30°C) and maximum summer temperature function (20°C)
is suitable for installation onboard and has a 230 V output for
solenoid valve control.
Cooler-convector/cooler-radiator;
the water temperature probe checks the temperature
inside the batteries and determines the start of the
fan based on the set parameters (minimum winter and
maximum summer functions). Check that it is inserted
correctly in the well on the battery;
- make the electrical connections, order the wiring and
fix the wires using the 3 supplied clamps (ref. G);
- close the box and fix with the 4 screws (ref. H);
- mount the aesthetic side panel on the Cooler-
convector/cooler-radiator;
- tighten the upper screw on the control panel;
* For versions with hydraulic connections on the right
refer to the relevant paragraph.
F
I
B
G
H
U
CS035
T_ARIA T_ACQUA SPARE
E_VALVE
I S
L