Abicor Binzel ABIMIG A Série Mode D'emploi page 30

5 Putting into operation
5.4.3 Torch neck liner
Only for ABIMIG
1
1 Torch neck
2 Torch neck liner
Fig. 4
1 Unscrew the torch neck (1) from the torch handle and optionally insert the sealing plug into
the torch handle.
2 Grind the torch neck liner (2) to an angle of 40° on the contact tip side (stripped side).
3 Introduce the torch neck liner (2) with the stripped side into the torch neck until the end stop
at the contact tip (4).
4 ABIMIG
Slide in the torch neck liner and shorten it at the end free of the retaining nipple until it flexibly
protrudes 2 mm from the retaining nipple.
ABIMIG
Cut off the torch neck liner (2) with an excess length of 12 mm from the current contact
area (3) free of burrs.
5 Deburr the cutting edges.
6 Where applicable, remove the sealing plug and screw the torch neck (1) into the torch seat
on the torch handle.
NOTICE
• Ensure that the current contact areas on the torch neck and torch neck seat are clean.
• For ABIMIG
it easier to insert the torch neck and extends the service life of the O-rings.
EN - 12
®
A T LW/ABIMIG
4
3
Torch neck liner
®
A T LW:
®
W T:
®
W T, grease the O-rings with silicone-free lubricant (192.0078). This makes
®
W T change neck torches.
Current contact area
ABIMIG
2
12
3
2
2
3
4 Contact tip
BAL.0402.0 • 2018-08-24
®