Junker JC4119960 Manuel D'utilisation page 55

Fault
The appliance is not working.
Appliance is not heating, colon is
flashing in the display.
Microwave operation is stopped.
Food takes longer than usual to
heat up.
The microwave does not work.
12:00 flashes in the display and
the symbol lights up.
The appliance is not in operation.
A cooking time is shown in the
display.
14.2 Information on display panel
Fault
A message with "D" or "E" ap-
pears in the display, e.g. D0111
or E0111.
The message appears in the
display.
The message appears in the
display.
Cause & Troubleshooting
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
3.
exact error message when calling.
→ "Customer Service", Page 69
Demo mode is activated in the basic settings.
Disconnect the appliance from power supply by briefly switching off the cir-
1.
cuit breaker in the fuse box.
Deactivate demo mode in the basic settings in the next 3 minutes.
2.
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
3.
exact error message when calling.
→ "Customer Service", Page 69
The microwave power setting was too low.
Select a higher microwave power setting.
▶
You have placed a larger amount of food than normal in the appliance.
Set a longer cooking time.
▶
Double the amount needs double the cooking time.
The food was colder than usual.
Stir or turn the food during cooking.
▶
The door was not fully closed.
Check whether food residue or debris is trapped in the door.
▶
has not been pressed.
Press ⁠ .
▶
There has been a power cut.
Reset the time.
▶
→ "Setting the time", Page 44
has not been pressed.
Press ⁠ .
▶
Cause & Troubleshooting
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
3.
exact error message when calling.
→ "Customer Service", Page 69
The automatic safety cut-out function has been activated.
Press any button.
▶
Moisture in the control panel.
Allow the control panel to dry.
▶
Troubleshooting en
55