Publicité
Les langues disponibles
Les langues disponibles
en Cleaning and servicing
Display
1
Factory setting (may vary according to model)
12.2 Changing the basic settings
Requirement: The appliance must be switched off.
Press and hold
for a few seconds.
1.
a The first basic setting is shown in the display.
Use the settings area to change the basic setting.
2.
Press
.
3.
a The next basic setting is shown in the display.
Use
to select all the required basic settings and
4.
change the values.
13
Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
13.1 Cleaning products
Only use suitable cleaning products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
Using oven cleaner while the cooking compartment is
still warm may damage the enamel.
Never use oven cleaner in the cooking compartment
▶
when it is still warm.
Remove all food remnants from the cooking com-
▶
partment and the appliance door before you next
heat up the appliance.
52
Basic setting
Interior lighting
Factory setting
Demo mode
Signal volume
Selection
= off
1
= on
1
= off
= on
1
= off
= on
= low
1
= medium
= high
To save the changes, press and hold
5.
seconds.
Tip: Your changes to the basic settings will be retained
even after a power cut.
12.3 Discarding changes to the basic
settings
Press
.
▶
a All changes are discarded and not saved.
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
13.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of burns!
The appliance gets very hot.
Never touch the inside surfaces of the cooking com-
▶
partment or the heating elements while they are hot.
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
WARNING ‒ Risk of fire!
Loose food remnants, fat and meat juices may catch
fire.
Before using the appliance, remove the worst of the
▶
food residues and remnants from the cooking com-
partment, heating elements and accessories.
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use glass scrapers, sharp or abrasive clean-
▶
ing aids, or harsh cleaning products.
Follow the instructions for
1.
→ "Cleaning products", Page 52.
Description
Switch the interior lighting
on or off.
Reset the changed settings
to the factory settings.
Switch demo mode on or
off.
Note: Demo mode is only
visible in the first 5 minutes
after connecting the appli-
ance to the mains.
Setting the signal volume.
for a few
Publicité
