Dimplex WPM 2006 plus Instructions De Montage Et De Service page 60

6.4
EN-20
Activation of special functions
Sets the duration of the individual steps during the
heating-down phase
Sets the temperature difference between the two
steps in the heating-up phase
Sets the temperature difference between the two
steps in the heating-down phase
Activates the individual program for screed drying
By activating this function, the difference between
flow and return flow is measured at the start of
defrosting. If the value is > 12 K, a fault is activated.
By activating this function, a 2-hour long block is
activated if an expected reduction in the flow
temperature does not take place
After-sales service functions
Displays the time to the next defrosting
Setting the required defrost temperature for hot gas
defrost
Setting for selecting the type of external sensor in
use.
Displays all the temperatures measured in the
heating system in compact form
Displays the statuses of all digital outputs in the
heating system in compact form
Displays the statuses of all digital inputs in the
heating system in compact form
Displays all the analogue values measured in the
cooling system in compact form
Displays all the digital inputs and outputs in the
cooling system in compact form
Display of all HP max. values for the domestic hot
water preparation in compact form
After this function is activated, all of the display
segments will be activated for approx. 10 seconds.
Setting of the overtravel time for the heat pump,
auxiliary pump and the domestic hot water pump.
Parameters of the thermal energy meter.
Display of the potential performance levels in the
cooling operating mode (1-2-3 possible) according
to the configuration of the system. Manual
switching to the desired performance level is
possible.
Display
1 Always
... 24...
120
1 K Always
... 5 K ...
10 K
1 K Always
... 5 K ...
10 K
No Always
Yes
No Air HP
Yes
No Air HP
Yes
Always
Always
2° C Air HP hot gas
defrost
... 6° C...
10° C
NTC-2 Controller without
integrated display
NTC-10
Always
Always
Always
Cooling function
Cooling function
Domestic hot
water
No Always
Yes
0 s Always
... 5 s...
420 s
Thermal energy
meter
Active cooling
function