Dimplex WPM 2006 plus Instructions De Montage Et De Service page 56

6.1
EN-16
System-specific parameters
Sets the time in which a swimming pool block is
to take place
For each day of the week, it is possible to select
whether Time1, Time2, no time or both times
are to be active for a swimming pool block.
Blocks that exceed a week day are activated or
deactivated at the end of each day accordingly.
The output of the auxiliary circulating pump can
be configured to allow parallel operation of the
auxiliary circulating pump and the heat pump's
compressor. Configuration is possible for
heating, DHW preparation and swimming pool
water preparation. The antifreeze functions are
ensured.
Should the auxiliary pump operate during
heating operation?
Should the auxiliary pump operate during
cooling operation?
Should the auxiliary pump operate during DHW
preparation?
Should the auxiliary pump operate during
swimming pool water preparation?
Is it desirable that the heat circulating pump
switches on and off as required? If optimization
is switched off (NO), the heat circulating pump
is run in continuous operation.
Sets the date, year, day, month and week day
The language for menu navigation can be
selected from the available languages
Setting range Display
00:00 Swimming pool
...
23:59
N Swimming pool
T1
T2
Y
Always
No Heating circuit 1
Yes
No Active or passive
cooling
Yes
No Domestic hot water
Yes
No Swimming pool
Yes
Yes Heating circuit 1
No
Always
DEUTSCH Always
ENGLISH
FRANCAIS
ITALIANO
NEDERLAND
PORTUGUES
POLSKY
SVENSKA
SLOVENSKO
ESPANOL
CESKY
SUOMI
NORSK
DANSK