D/A Converter Mode; Changing The Input Source; Dimmer - Esoteric K-01X Mode D'emploi

D/A converter mode

This unit can be used as a D/A converter when its input source is set
to an external digital input (COAX in, OPT in or USB in).

Changing the input source

When stopped, press the MODE button repeatedly to cycle through
the following input sources.
CD/SACD
USB in
(USB input for
computer)
o When an external digital input (COAX in, OPT in, USB in) is
selected, the name and sampling frequency of the selected input
appears on the display. If there is no input signal or the input sig-
nal is not locked, the input sampling frequency is not shown and
the input name blinks.
o If the input signal is not a digital audio signal or uses an audio sig-
nal format that is not supported by this unit (such as Dolby Digital,
dts or AAC) "- - -" appears in place of the sampling frequency. Set
the digital output of the connected equipment to PCM audio
output.
o When an external input (COAX in, OPT in, USB in) is selected,
disc controls other than the tray open/close (-) button do not
function.
COAX in
(coaxial digital input)
OPT in
(optical digital input)

Dimmer

You can adjust the brightness of this unit's display and indicators.
FL Dimmer3
c
FL Dimmer2
c
FL Dimmer1
c
Off
o If you select "Off", the display and the indicators will be unlit.
o In this mode, the display will light at normal brightness for about
three seconds when you press 7 or another button.
o Even when set to any value other than Dimmer3, normal bright-
ness (Dimmer3) will be used when displaying error messages and
setting menus.
(normal
brightness)
21