Using The Machine For The First Time; Circuit Priming - Gaggia Milano NAVIGLIO MILK Mode D'emploi

MAN. GAG. NAVIGLIO MILK USA EN.indd 13

Using the Machine for the First Time

When using the machine for the first time, the following activities need to happen:
1 the circuit needs to be primed;
2 the machine will perform an automatic rinse cycle.
3 you need to perform a manual rinse cycle.

Circuit Priming

During this process, fresh water flows through the internal circuit to heat up the
machine. This takes a few minutes.
1 Place a container under the steam wand.
2 Press the " " button for 5 seconds to start the cycle. The machine starts the
automatic priming of the circuit by dispensing some water through the steam
wand.
3 When this process has been completed, the "
The machine is heating up.
ENGLISH
" e " " buttons will flash.
05/11/2019 11:37:39
13