Publicité
Les langues disponibles
Les langues disponibles
Key Beep
ON
Buzzer
ON
Input power low
Cut-off
10.0V
Select Language
English
Select Language
Deuts
LitHiUM BattEry (LiLo/Lipo/LifE) prograM
These programs are only suitable for charging and discharging Lithium batteries with a nominal voltage
of 3.3V, 3.6V and 3.7V per cell. These batteries need to adopt different charge technique is termed a
constant voltage (CV) and constant current (CC) method. The charge current varies according to the
battery capacity and performance. The final voltage of charge process is also very important; it should be
precisely matched with the charade voltage of the battery. They are 4.2V for LiPo, 4.1V for Lilo, and 3.6V
for LiFe. The charge current and nominal voltage as for cell count set on the charge program must always
be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press Start/Enter key to make it blink
then change the value with INC or DEC key. The value will be stored by pressing Start/Enter key once.
SafE tiMEr caLcULation
When charging NiCd or NiMH batteries, divide the capacity by current, then divide the result by 11.9, set
this number of minuters as the value for safety timer setting. If the charger stopped at this time thresold,
about 140% of the capacity will have been fed into the battery.
For example :
Capacity
Current
2000 mAh
2.0A
3300 mAh
3.0A
1000 mAh
1.2A
cHarging LitHiUM BattEry
LiPo
Charge
2.0A
11.1V(3S)
After setting the current and voltage press Start/Enter key for more than 3 seconds to start the process.
(Charge current: 0.1 - 5.0A, Voltage: 1 - 6 series)
8
The beep sounds at every time pressing the buttons to confirm your action.
The beep or melody sounded at various times during operation to alert different
mode changes. These audible sounds can be on or off.
This program monitors the voltage of input DC battery. If the voltage drops
below the value you set the operation forcibly terminated to protect the input
battery.
SELECT LANGUES :
Press"Start/Enter" button again, and a beep will be sound,you can see the
"English" is flashing, at this moment, please press "DEC"or "INC" to select language.
The screen shows the language (Germany).
Safety time
(2000/2.0=1000)/11.9=84 minutes
(3300/3.0=1000)/11.9=92 minutes
(1000/1.2=1000)/11.9=70 minutes
The left side of the first line shows the type of battery you select at the users setting.
The value on the left side of second line sets a charge current and the value on the
right side of second line sets the voltage of the battery
Publicité
