Konect multi80+ Mode D'emploi page 3

SpEciaL fEatUrES
optimized operating software
When charging or discharging, it has an "AUTO" function that sets the feeding current automatically.
Especially for Lithium batteries, it can prevent the over-charging can lead to an explosion by users fault.
Every program in the unit is controlled with mutual links and communication for every possible error so it
introduces a maximum safety. These can be set at users option.
internal independent lithium battery balancer
It has an individual-cell-voltage balancer inside. So it does not need any balancer separately when charging
Lithium batteries (Lilon/LiPo/LiFe) for cell voltage balancing.
Balancing individual cells battery discharging
It also can monitor and balance individual cells of the Lithium battery pack during the discharge process. If
the voltage of any one cell varies abnormally, the process will be stopped with the error message.
adaptable to various types of Lithium battery
It can accept three types of Lithium batteries: Lilon, LiPo and LiFe. They have different characteristics by
their chemistry. You can select any one of them that you are going to process before the job. For their
specifications, refer to "Warnings and safety notes" section.
Lithium battery "fast" and "Storage" mode
You can charge Lithium battery for special purposes. "Fast" charge reduces the charging time of Lithium
battery and "Storage" mode controls the final voltage of the battery to be suit for long time storage.
Maximum safety
• Delta-peak sensitivity: The automatic charge termination program works on the principle of the Delta¬peak
voltage detection (NiCd/NiMH). When the battery's voltage exceeds the threshold, the process
• will be terminated automatically.
• Auto-charge current limit: When charging NiCd or NiMH at "AUTO" current mode, you can set the upper
limit of charge current to avoid from high current charging. This is very useful when charging the low
impedance and small capacity NiMH battery in "AUTO" mode.
• Capacity limit: The charging capacity always calculated by multiple of the charging current and time. If
the charging capacity exceeds the limit the process will be terminated automatically when you set the
maximum value.
• Temperature limit: The temperature of the battery on charging will rise by its internal chemical reaction.
If you set the limit of temperature the process will be expired forcibly when the limit has reached.
* This function is available by connecting optionnal temperature probe, which is not included in our
package
• Processing time limit: You can also restrain the maximum process time to prevent from any possible defect.
• Input power monitor: To protect the car battery using as DC input power from being damaged the
voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
Data store/load
For users convenience it can store maximum 5 data of different batteries. You can establish the data
contains program setting of the battery to charge or discharge continually. These data can be called out
at any time you need and the process can be executed without program setting.
cyclic charging/discharging
Perform 1 to 5 cycles of charge> discharge or discharge> charge continually for battery refreshing and
balancing.
3