Konect multi80+ Mode D'emploi page 14

End Voltage
12.6(3S)
Capacity Cut-Off
ON 5000mAh
Safety Timer
ON 200min
USB/Temp Select
USB Enabled
Ext.Temp 26C
IN Power Voltage
12.56V
4.14 4.16 4.09
0.00 0.00 0.00
SELEct ExtErn fUnction prograM
In this program,you can select extern function of battery
1> MEASURE INTERNAL RESISTANCE PROGRAM PER CELL (ONLY FOR LITHIUM BATTERIES)
In this program,the charger can ont only measure the internal resistance of the battery pack,and also can
measure the per-cell internal resistance (only available for lithium battery).
1> Measure IR
---->
C1:3 3 3mQ
C4:3 0 0mQ
14
The final voltage will be reached at the end of process.
The 3-pin port is assigned as an USB port.
The external temperature only will be displayed when using the thermal
probe.
The present voltage of input power.
Using the individual connection cable to the battery, you can check the
individual voltages of each cell in the battery pack. When connect the cable
to the port on the right side of the charger the program shows the voltage
of each cells for maximum 6 cells in sequence. To utilize this feature, the
battery pack must have output connector that linked to each cells.
Press « Start » : The battery pack start to measure internal resistance per cell.
The two lines shows the first to the sixth cell's internal resistance, which
is only available for the lithium battery. Press "DEC"or"INC" to dispaly more
information.