Konect multi80+ Mode D'emploi page 2

Thank you for purchasing the
balance, which is computerized with a high performance microprocessor and specialized operating software.
Please read this entire operating manual completely and attentively as it contains a wide variety of specific
programming and safety information.
SpEcificationS
Operating voltage range: DC 11.0 - 18.0 Volt
Circuit power: Max. charge power 80W [DC Input]
Max. discharge power 10W
Charge current range: 0.1 ~ 8.0A
Discharge current range: 0.1 ~ 2.0A
Current drain for balancing Li-po: 460mAh/cell
NiCd/NiMH battery cell count: 1 ~ 15 Cells
Lithium battery cell count: 1 ~ 6 Series
Pb battery voltage: 2 ~ 20V
Net Weight: 590g
Dimensions: 135 x 145 x 43mm
WHat'S nEW in MULti80+
• Max charge current reach to 8A instead of 6A, that means that it can speed up your charge by
increasing the charge current.
• Max balance current increase to 460mA from 300mA, that means it can speed up the balance charge
of your lithium batteries.
• 15 extra functions provide more convenience for your hobby time.
1. LANGUAGES: There are 2 languages which you can select (English and Deutsch).
2. CELL METER: The charger can test the voltage of each cell of your batteries.
3. CAPACITY: Check the capacity of the battery.
4. IR: The battery pack measures internal resistance.
5. BALANCER: The charger can balance the voltage of each cell of your battery.
6. DIGITAL POWER: Using the charger's output as a DC power supply.
7. BRUSH MOTOR: You can easily beak-in new brushed electric motor using a variable voltage and
running time.
8. FOAM HOT CUTTER: The charger acts as a convenient power supply for a hot wire foam cutter.
9. MOTOR/ ESC/SERVO: The charger can output the PPM signal instead of your TX for your MOTOR/
ESC/SERVO, you can see it's working status.
10. BRUSHLESS MOTOR: The charger can drive an inductance brushless motor.
11. SERVER TEST: The charger can test the server.
12. THRUST CALCULATOR: You can easily calculate the thrust of a propeller.13. TEMP.: The charger can
measure the external temperature by using a temperature sensor.
14. VOLTAGE METER: The charger can measure the DC voltage of an object.
15. PPM TEST: The charger can test the PPM signal from TX, so that you can check out some problem
between your Tx and RX.
2
Charger. You get a rapid charger/discharger with a built-in
AC to DC adaptator (DC 11.0 ~ 18.0V)