Konect multi80+ Mode D'emploi page 19

BATTERY VOL ERR
CELL HIGH VOL
TEMP OVER ERR
CONTROL FAILURE
gLoSSary of tErMS
• Amps(A): The unit of measure for charge or discharge electric current. The program of the charger will
show most of the current in amps(A) at its LCD screen.
• Milli-amps(mA) : The electric current, being amps(A) multiplied by 1000 and noted as "mA". So 2.0A
is the same as 2000mA (2.0*1000). Or, to convert mA to amps, divide the mA number by 1000. So
200mA is the same as 0.2A. If a current value is below 1.0A, the LCD screen of the charger will still
show the current in amps, not milli¬amps. For example, a current of 600mA will be displayed as 0.6A,
and a current of 100mA will actually be shown as 0.1A.
• Capacity, milli-amp hours (mAh), and amp-hours (Ah): Charge energy stored by a battery is called
capacity, which is defined as how much current a battery can supply constantly over one hour of time.
Most hobby batteries are rated for capacity in "mAh" or milliamp hours. A 650mAh battery can deliver
650mA of current for one hour (650mA*1hr=650mAh). The batteries of very large capacity, such as
lead-acid(Pb) batteries, are usually rated in "Ah" or amp-hours. A "12V 60Ah" car battery can deliver 60
amps of current for one hour (60Ax*1hr=60Ah).
• Nominal voltage(V) : The nominal voltage of the battery pack can be determined as follows :
-NiCd or NiMH: multiply the total number of cells in the pack by 1.2. A 8-cell pack will have a nominal
voltage of 9.6 volts (8*1.2).
-LiPo: multiply the total number of cells in the pack by 3.6. A 3-cell Lilo wired in series will have a nominal
voltage of 11.1 volts (3*3.7).
-Lilo: multiply the total number of cells in the pack by 3.6. A 2-cell Lilo wired in series will have a nominal
voltage of 11.1 volts (3*3.6).
-LiFe: multiply the total number of cells in the pack by 3.3. A 4-cell Lilo wired in series will have a nominal
voltage of 11.1 volts (4*3.3).
• If the nominal voltage of the battery is not printed on the battery's label, consult your battery manufacturer
or supplier. Do not guess the rated voltage of battery.
• "C"-rating: Capacity is also referred to as the "C" rating. Some battery suppliers recommend charge and
discharge currents based on the battery "C" rating. A battery's "1C" current is the same number as the
battery' s rated capacity number, but noted in mA or amps. A 600mAh battery has a 1C current value of
600mA, and a 3C current value of (3*600mA) 1800mA or 1.8A. The 1C current value for a 3200mAh
battery would be 3200mA(3.2A).
There are bad connection at the individual connector. Please check the
connector and cables carefully.
The internal temperature of the unit goes too high. Cool down the unit.
The processor can not continue to control the feeding current by any reason.
The unit needs to be repaired.
19