Change the Crankcase Oil
1� Place the vehicle on the level ground and park the vehicle�
2� Start the engine and warm for ( 2 ~3 ) minutes, then stop the
engine�
3� Place a pan under the engine drain hole ( 1 ) to store the engine
oil�
4� Remove the dipstick and wipe it clean�
5� Remove the crankcase magnetic drain bolt ( 3 ) and washer ( 2 )
to drain out the oil�
6� Confirm the crankcase is drained completely.
7� Remove the three oil filter cover bolts ( 4 ) .
8� Remove the oil filter cover ( 5 ) .
9� Inspect the O-ring ( 6 ) in the cover, to ensure it is in good
condition. Replace with a new one if damaged.
10� Mount O-ring ( 6 ) into the oil filter cover, and apply a layer of
fresh engine oil for lubricating.
11� Install a new oil filter ( 7 ) .
12� Mount oil filter cover ( 5 ) , then install and tighten the cover bolts
to the specified torque.
MAINTENANCE PROCEDURES
138
1
2
3