Sharp LL-S242A-W Manuel D'installation page 11

nLL-S242A-W
Placement on the rack stand
Place the unit on the supplied rack stand.
1. Attach the back of the stand to the front.
Place the front and back sides together, and attach the
hinge.
Front hinge part
Front
Front
2. Spread the base of the front and back sides.
Installation (Continued)
Back
Back hinge part
Tape
Back
Support
3. Peel off the adhesive tape securing the support to the
back side.
4. Fold down the support, inserting the tabs into the
holes on the front side.
5. Position the stand.
6. Place the monitor in the stand.
Landscape orientation
Run the cables out between the legs of the back side.
Tape
Back
Support
9
E