LEGRAND KEOR HPE 100 kVA Manuel De Fonctionnement page 45

3.2 HANDLING OF THE UPS
The UPS is packed on a pallet. It is handled from the transport vehicle to the installation (or storage)
place via a fork lift.
The device has a heavy weight
 Avoid turnover during the transport of the UPS.
 Cabinets must always be handled in upright position.
 During loading and unloading operations, always respect the indications
regarding the device barycentre marked on the package.
Before positioning the UPS, in order to avoid risks of turnover, it's recommended to move the system
on the wood pallet on which the UPS is fixed. Before the positioning in the final location, remove the
UPS from the pallet.
To handle the UPS remove the lower front, rear and side panels and insert the forks of a fork lift. The
UPS can be handled both from the front and from the side according to the available spaces, as
shown by the following picture.
Picture 2 – Handling of the KEOR HPE UPS 100÷160 kVA
20 OML46086 REV. L
Installation and start-up of KEOR HPE UPS 100÷160 kVA
Installation et démarrage de l'ASI KEOR HPE 100÷160 kVA
Installazione e avviamento KEOR HPE UPS 100÷160 kVA