Guarantees; Operating And Programming; Control Panel - Astralpool 73082 Manuel D'installation Et D'entretien

3.3 GUARANTEES.

The valves leave the factory in a fully tested condition, which enables us to guarantee operation. The
guarantee will be effective provided that the installation and maintenance has been correctly carried
out and this requires that the actual installation operation be performed by a person with the necessary
qualifications for this type of work. A specific sheet with the valve warranty is attached to the manual.
4. OPERATING ANG PROGRAMMING

4.1 CONTROL PANEL

The valve incorporates in the electronic module cover a panel with push buttons and LEDs to indicate the
function being performed by the valve.
The LEDs on the wheel correspond to the position of the valve. They also indicate with short flashes if the
valve moves to that position and with long flashes if the programme has remained in the memory in case
of pump stops.
Backwash cycle interval: it is possible to program a backwashing cycle every 3 days, 5 days or 7 days
backwashing.
Backwash time: the push buttons can increase or reduce the backwash time and the activation of one of
the LEDs shows the minutes of programmed wash. It flashes when the function is running.
Rinse time: the buttons can increase or reduce the rinse time and the activation of one of the LEDs shows
the rinse time selected. It flashes when the function is running.
Blower time: press button to increase or decrease the time of blowing in Rinse position.
If there is a power cut, the backwash and rinse times will remain stored in the valve until the valve has
the power supply again.
Power supply: LED that indicates that the valve's power supply connection has
been correctly done.
MODBUS Communication: In case of connection is done through MODBUS, it
indicates when data is sent or received.
Backwash cycle button: Press button to activate the wash + rinse programme.
Waste button: Press button to activate the emptying function.
Recirculating button: Press button to activate the recirculation function and
LED indicates that the function is in process.
Closed button: Press button to move the valve to closed position.
11
ENGLISH