Stopping Ironing; Ironing With A Payment System - Miele PRI 210 Mode D'emploi

Stopping the roller During ironing, press down the footswitch with your foot.

The roller stops moving. The heater plate remains engaged.
Remove your foot from the footswitch again to continue ironing.

The roller automatically begins to rotate again. The ironing process
continues.
Alternatively, the footswitch can be adjusted by Miele Service in
such a way that the heater plate exits Pause mode and the roller be-
gins to rotate when the footswitch is activated (domestic setting).

Stopping ironing

After ironing, let the roller run for about 10 minutes at the minimum

heating temperature without feeding in any laundry to dry out the
roller cover completely.
Switch off the flatwork ironer by pressing the  button.

The heater plate disengages and the fan runs for up to 10 minutes to
cool down the ironer. The  button flashes during this process.
Switch off the on-site main switch.


Ironing with a payment system

Press the  button to switch on the ironer.

The  symbol flashes.
Now insert the coin or token into the payment system.

The  symbol will go out in the display.
Select the appropriate ironing temperature for the type of fabric.

Then select the desired roller speed.

When the  indicator light goes out, the set target temperature
has been reached and the ironer is ready to start ironing. This is in-
dicated by a buzzer sounding.
The ironing time purchased starts when the buzzer sounds.
Press the  button to start the ironing process.

If ironing commences before the target temperature is reached, the
timer starts counting down when the  button is pressed.
The heater plate engages and the roller begins to rotate.
After the purchased ironing time has expired, the ironer emits an aud-
ible signal to indicate that the run-on time has started. The preset de-
fault run-on time is 1 minute.
You can now finish ironing the item that has been fed in.

en - Use
169