En - Warning And Safety Instructions; Appropriate Use; Technical And Electrical Safety - Miele PRI 210 Mode D'emploi

en - Warning and Safety instructions

Read the operating instructions carefully before using the flatwork ironer. They contain
important information on safety, installation, use and maintenance.
To avoid the risk of accidents or damage, it is essential to read the operating instructions
before using the ironer for the first time.
If other persons are being shown how to operate the ironer, they must be given or made
aware of these important safety instructions.
Miele cannot be held liable for injury or damage caused by non-compliance with these
instructions.
Keep these operating instructions in a safe place and pass them on to any future owner.

Appropriate use

This flatwork ironer must be used as described in these instructions and must be checked
on a regular basis to make sure it is functioning correctly.

This flatwork ironer is only intended for ironing clean fabrics that were washed in water.
Check fabric care labels to verify that the articles are suitable for machine ironing.

This flatwork ironer is intended for use in commercial settings. The flatwork ironer is not
intended for domestic use. If the flatwork ironer is used in a publicly accessible place, it is
the supervisor's responsibility to ensure suitable measures are in place to protect users
from any source of risk or danger.
Gas-heated flatwork ironers are not suitable for use in publicly accessible places.

The flatwork ironer is not intended for outdoor use.

Technical and electrical safety


The flatwork ironer must not be operated in the same room as dry-cleaning equipment
using perchloroethylene or solvents containing CFCs.

The flatwork ironer may only be operated in a suitable dry room.

Only operate the flatwork ironer when all removable outer panels are in place so that it is
impossible to touch an electrical component, moving part or hot machine parts.

Do not damage, remove or bypass the safety features or control elements of the flat-
work ironer.

Do not make any alterations to the flatwork ironer unless explicitly authorised to do so
by Miele.

If the control elements or the electrical cabling insulation has been damaged, the flat-
work ironer must not be used until such damage has been repaired.

Repairs may only be carried out by suitably qualified personnel. Incorrect repairs can
cause considerable danger to users.

Faulty components may only be replaced by genuine Miele spare parts. Miele can only
guarantee that the flatwork ironer fully complies with safety requirements if Miele genuine
replacement parts are used.
154