Removal Of Ironed Laundry; Pausing The Ironing Process; Standby Mode; Flexcontrol" Footswitch - Miele PRI 210 Mode D'emploi

en - Use
Removal of ironed
laundry
Pausing the iron-
ing process

Standby mode

"FlexControl"
footswitch
168
Feed the item of laundry evenly into the ironer.

Do not feed small items of laundry into the ironer on only one side.
If laundry infeed is on just one side, the heat will only be used on
one side and the load only exerted on the roller padding on one
side. If the laundry infeed continues to be on one side only, this will
be indicated by a buzzer and the red  symbol or  symbol ap-
pearing in the display.
Use the entire roller width wherever possible and distribute small
items of laundry evenly on the laundry in-feed table.
The picker springs on the laundry picker band separate the ironed
laundry from the roller. The laundry can then be removed from the
ironer.
 Risk of burning due to hot edges of the heater plate outfeed.
While the ironer is in use, the heater plate becomes very hot. Ironed
laundry may also be very hot when it emerges from the heater
plate.
Always take care when removing ironed laundry from the appli-
ance.
Do not touch the edges of the heater plate outfeed.
If a picker spring is loosened from its position, the ironer must be
switched off. The picker spring then needs to be moved by hand to
the original position of the laundry picker band.
 Risk of fire due to laundry self-ignition.
Hot laundry could self-ignite and cause a fire.
Allow the ironed laundry to cool down before packing or stacking it.
Press the  button to interrupt the ironing process and switch the

appliance to pause mode.
In pause mode, the roller stops and the heater plate disengages. The
heater of the ironer will initially remain switched on. During pause
mode, the ironer remains ready for use.
Press the  button to start ironing again.

After an adjustable period of non-use, the ironer can switch to
standby mode. In standby mode, the roller is at a standstill and the
heater plate is disengaged. During this process, the ironer heater is
switched off as well.
Press the  button to switch the ironer back on.
Standby mode is deactivated by default. Standby mode can be ac-
tivated at service level by the Miele Customer Service Department.
The time at which the ironer will switch to standby mode can be ad-
justed to a value between 1 and 30 minutes of non-use.
Activating the moveable footswitch stops the roller. This makes it
easy to avoid mistakes when feeding in items.