EINHELL 15.440.10 Mode D'emploi D'origine page 14

Anleitung_BT_EW_150_V_SPK1__ 20.01.14 09:52 Seite 14
GB
cause fires. Keep a fire extinguisher nearby and
someone watching who can use it immediately.
Do not weld on drums or any closed containers.
d) Danger from welding arc radiation: Welding arc
radiation can damage your eyes and injure your
skin. Wear a hat and safety goggles. Wear ear
protection and a high, closed shirt collar. Use a
welding helmet and filters of the correct size.
Wear complete body protection.
e) Danger from electromagnetic fields: Welding
current creates electromagnetic fields. Do not use
together with medical implants. Never wind the
welding cables around your body. Guide welding
cables together.
4. SYMBOLS AND TECHNICAL DATA
EN 60974-6 European standard for arc welding
sets and welding power supplies with
limited on time (Part 6).
Symbol for welding power supplies
S
which are suitable for welding in
environments with increased
electrical danger.
~ 50 Hz Alternating current and rated
frequency value [Hz]
U 0 Rated idling voltage [V]
100 A/ 22 V Maximum welding current and the
corresponding standardized
operating voltage [A/V]
Ø Electrode diameter [mm]
U 2 Welding voltage [V]
I 2 Welding current [A]
t w Average load time [s]
t r Average reset time [s]
Line input; number of phases, the
alternating current symbol and the
1 ~ 50 Hz
rated frequency value
U 1 Line voltage [V]
14
I 1max Highest rated value of the line
current [A]
I 1eff Effective value of the highest line
current [A]
IP 21 S Protection type
H Insulation class
Mains connection:
Welding current (A) at cos Ê = 0.73:
ø (mm) 1,6
I 230 V 40
2
t (s) 230 V 417
w
t (s) 230 V 694
r
Idling voltage (V):
Power input: 4 kVA at 80 A cos Ê = 0.73
Fuse (A):
The welding times apply for an ambient temperature
of 40° C.
5. Welding preparations
Connect the earth terminal (-) (2) direct to the part to
be welded or to the support on which the part is
resting. Ensure that the earth terminal (-) is in direct
contact with the part to be welded. You should
therefore avoid coated surfaces and/or insulated
materials. The electrode holder cable has a special
clamp at one end, which is used to secure the
electrode. The welding safety shield must be used at
all times for welding. It protects your eyes from the
radiation emitted by the arc and nevertheless
enables you to watch the welding process (not
included in items supplied).
6. Welding
After you have made all the electrical connections for
the power supply and for the welding circuit, you can
proceed as follows:
Insert the unsheathed end of the electrode into the
electrode holder (1) and connect the earth terminal
(-) (2) to the part you wish to weld.
Ensure that a good electric contact is made.
Switch on the welding set at the switch (4) and set
the welding current using the hand wheel (3) to suit
the electrode you wish to use.
230 V ~ 50 Hz
40 - 100
2,0 2,5 2,5
55 80 100
217 110 79
689 669 755
48
16