DeWalt XR DCN693 Traduction De La Notice D'instructions Originale page 61

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
For more serious or persistent problems, contact your nearest authorised D
or contact your D
WARNING: To reduce the risk of serious personal injury, ALWAYS lock off the tool and disconnect
battery pack from tool before all repairs
SYMPTOM CAUSE
Motor does not run with Trigger lock in locked position
contact trip depressed
Dry drive lock out engaged, blocking
contact trip from traveling fully
Tool is stalled, locking the motor from
rotating
Bent contact trip
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Tool does not Dry drive lock out engaged, blocking
actuate (motor runs but contact trip from traveling fully
will not drive a nail)
Low battery charge or damaged battery
Jammed nail/drive blade not returned to
home position
Damaged driver/return assembly
Jammed internal mechanism
Damaged internal electronics
Motor starts up but Jammed nail and driver blade is stuck in
generates a lot of noise down position
Damaged driver/return assembly
Drive blade continues Jammed nail and driver blade is stuck in
to get stuck in down down position
position
Damaged driver/return assembly
Material and fastener length
Debris in nosepiece
Tool is not yet run-in
Use of incorrect speed (DCN693 only)
All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE
WALT office at the address indicated in this manual.
e
WALT repair agent,
e
FIX
Unlock trigger lock.
Load more nails into magazine.
Rotate the stall release lever on the tool and the
mechanism will release. If driver blade does not
return, remove battery and manually push driver
blade back to home position.
See authorised D WALT repair agent.
e
Normal operation, release contact trip and
redepress.
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Load nails into magazine.
Check charge level if pack shows state-of-charge.
Charge or replace battery pack if necessary.
Remove battery, clear jammed nail, cycle stall
release lever, (push driver blade up manually if
necessary) reinsert battery pack.
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
Use stall release lever, clear any jammed nails, and
return driver blade manually if necessary.
See authorised D WALT repair agent.
e
Use stall release lever, clear and jammed nails, and
return driver blade manually if necessary.
See authorised D WALT repair agent.
e
If the unit continues to stall (forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous an application.
Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
english
59