Set Closing And Opening On Torque Or Position; Set Torque Limits - Bernard Controls AQ Logic RANGE Instructions De Mise En Service

All manuals and user guides at all-guides.com

5.3 Set closing and opening on torque or position

This section allows you to define the way you want to stop actuator
travel in both directions. You can choose either Position or Torque.
How to set opening and closing type of end of travel
1. Enter the
commissioning > Choose to close on torque or position.
2. Select your option with
3. Select Save then validate with OK.

5.4 Set torque limits

This setting allows to set torque limits at main steps of the travel:
at the beginning (Break), during the travel (Run) and at the end of
the travel (End).
Limits are:
•
In closing direction:
Break to Close (BTC), Run to
Close (RTC), End to Close (ETC),
Tight zone
•
In opening direction:
Break to Open (BTO), Run to
Open (RTO), End to Open
(ETO), Tight zone
English
menu, then go
or

25
25
Settings
to

then confirm with OK.
Actuator
>