Bernard Controls AQ Logic RANGE Instructions De Mise En Service page 27

All manuals and user guides at all-guides.com
5. To set Break limits
• To set No limit, use
then ESC.
• To set another value, validate 1
then set 2
rd
When 3
and validate with OK.
You get back to the list of torque limit settings.
6. To set Run, End limits and Tight zone
Set each digit value with
Validate Continue with OK.
7. When you set all limits required, select Save and validate
with OK.

or
nd & 3 rd with

digit is validated with OK, go to Continue with

English

on 1 st digit,
digit with OK
st

or then validate each with OK.

then validate with OK.
or
27
