Dometic 10 Serie Instructions De Montage page 12

Installing the refrigerator
• The refrigerator must be installed in a recess so that it stands secure when the
vehicle is in motion. Note the dimensions in fig. 1, page 3
for this purpose.
Note the following recess dimension (fig. 2, page 4):
Refrigerator height (A)
Refrigerator width (B)
Refrigerator depth (C)
(excludes control knob
5 mm)
Recess height (H)
Recess width (W)
Recess depth (D)
• The refrigerator must be installed with a minimum distance of 5 mm from the floor
to ensure that the door can be opened properly (fig. 3, page 4).
– Make sure that no carpets interfere with the free movement of the door.
– Avoid placing the refrigerator directly on the floor.
4.2 Installing the condensate drain
Condensation can form inside the refrigerator due to frequent door opening, incor-
rectly stored food or food that is stored when it is too warm. Condensation must be
drained with a constant slope.
Install the condensate drain as follows:
➤ Run the condensation water hose from the refrigerator through an opening in the
floor which goes outside.
4.3 Connecting the power supply
The electrical power supply must be connected by a qualified electrician
who has demonstrated skill and knowledge related to the construction
and operation of electrical equipment and installations, and who is famil-
iar with the applicable regulations of the country in which the equipment
is to be installed and/or used, and has received safety training to identify
and avoid the hazards involved.
12
RCD10.ES, RCD10.5ET
1283 mm
523 mm
550 mm
1290 mm
528 mm
568 mm
RCD10.5
fig. 3, page 4
and
RCD10.XES, RCD10.5XET
1283 mm
523 mm
605 mm
1290 mm
528 mm
623 mm
EN