Dogtra ARC1200S FREE PLUS Manuel Du Propriétaire page 42

10. Attaching the Belt Clip
Follow the instructions below to attach the included belt
clip to the transmitter.
1. Align the belt clip to the grooves on the back of the
transmitter.
2. With a firm grip, screw on the belt clip's Phillips head
screws with a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over
tighten.
78
11. Using the Test Light
1. Turn on the receiver by pressing the on/off button. The
indicator light will come on for a moment then blink
once every 4 seconds, showing that the receiver is
ready to use (the receiver needs to be charged if the
indicator light is red).
2. Turn the transmitter on by holding down the on/off
button on the right side of the transmitter. The LED will
blink every 4 seconds and the LCD screen will show
the remaining battery life (the transmitter needs to be
charged if there is only 1 bar showing on the battery
icon for the LCD transmitter screen).
3. Place the test light, included in the package contents,
on the contact points as shown in the diagram.
4. Watch the test light as you press the Nick button on
the transmitter. It should light up for just a moment.
The higher the intensity, the brighter the test light will
be.
5. Watch the test light as you press the Constant button
79