Bella 14124 Manuel D'instructions page 10

12. Allow a few seconds for all steam to escape. Inspect and test food for doneness and adjust seasonings if
needed.
13. If cooking is completed before the timer reaches 00:00, press the MODE button until WARM is illuminated.
04:00 (4 hours) will appear on the display. Continue to press the UP or DOWN arrows until the target
WARM TIME is displayed.
14. Slow cooked food can be served directly from the aluminum pot, if desired.
NOTE: When serving from the Programmable Slow Cooker, always place a trivet or protective padding
under the slow cooker body before placing it on a table or countertop.
To Program Your Slow Cooker
1. The chart below: Temperatures & Times (Figure 7), lists LOW, HIGH or WARM temperatures and
corresponding default cooking times.
Figure 7:
Press MODE button
2. Plug cord into a 120V AC outlet. An audible beep will sound; the blue backlit screen will illuminate; all
numbers and icons on the screen begin to flash. After 60 seconds of inactivity, the slow cooker will turn
OFF.
3. Press the POWER button. The default screen (4:00 hours, HIGH) will begin to flash. (See Figure 8A ).
Figure 8 A
4. If no buttons are pressed in 5 seconds, the Slow Cooker will begin operation, or press POWER button to
begin cooking immediately. The COOK (cooking pot) icon will illuminate; the timer will count down to
00:00. (See Figure 8B).
5. To adjust cook time to 3 hours, press the DOWN arrow until the target cook time (3:00) is displayed.
(See Figure 8C.)
6. If no buttons are pressed in 5 seconds, the Slow Cooker will begin operation, or press POWER button to
begin cooking immediately.
7. The COOK (cooking pot) icon will illuminate. (See Figure 8D.); the timer will count down to 00:00; 3 audible
beeps signal cook time is complete.
8. Temperature will automatically drop to WARM and 04:00 (4 hours) will appear on the display. When
WARM time counts down to 00:00 the Slow Cooker will automatically turn OFF and the display
will turn blank.
NOTE: Press the POWER button at any time to turn the Programmable Slow Cooker OFF.
9. Press front lid lock, then use the lid knob to lift the hinged Slow Cooker lid.
10. Allow a few seconds for all steam to escape. Inspect and test food for doneness and adjust
seasonings if needed.
11. If cooking is completed before the timer reaches 00:00, press the MODE button until WARM is illuminated.
04:00 (4 hours) will appear on the display. To change the default WARM time, press then TIME button
once, then continue to press the UP or DOWN arrows until the desired target WARM time is displayed.
All manuals and user guides at all-guides.com
1 times
2 times
3 times
B
Temp Default Time
HIGH
LOW
WARM
C
8
4:00
8:00
4:00
D