Roborock Q5 Mode D'emploi page 9

Cleaning Mode Switch
• Suction Power Levels
• Custom
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
More Features
• Firmware Update
• Volume Adjustment
• Language Selection
• Do Not Disturb Mode
• Voice Assistant Support
Note: Functions and details of the app may vary slightly due
to the continuous app development and updates.
Routine Maintenance
C
Main Brush
C1
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Bearing
C1-5—Turn over the robot and press the
latches to remove the main brush cover.
Pull out the main brush and remove the
main brush bearing.
C1-6—Use the main brush cleaning tool to
remove any hair entangled around the
main brush.
Notes:
• If there is a large amount of hair, or hair is tightly entangled,
remove it carefully to avoid damage to the main brush.
• Use the main brush cleaning tool carefully to avoid injury.
Keep out of reach of children.
C1-7—After removing the tangled hair or dirt
at the main brush, reinstall it, press on the
main brush cover to lock it in place.
Notes:
• Main brush should be wiped down with wet cloth and left
to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
C2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush. Reinstall
the brush and tighten the screw.
Omni-Directional Wheel
C3
* Clean as required.
C3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
Note: The omni-directional wheel bracket cannot be removed.
C3-2—Rinse the wheel and the axle with
water to remove any hair and dirt. Dry
and reattach the wheel, pressing it firmly
in place.
09
Main Wheels
C4
* Clean monthly.
Clean the main wheel with a soft, dry cloth.
Dustbin and Washable Filter
C5
* Clean every week. Filter should be replaced every 6-12 months.
C5-1—Take out the dustbin.
C5-2—Remove washable filter and empty
the dustbin.
C5-3—Rinse the dustbin with water.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-4—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-5—Allow 24 hours for the dustbin and
filter to dry thoroughly and reinstall them.
Note: Purchase an additional filter and alternate if necessary.
Robot Sensors
C6
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C6-1—Dock Locator
C6-2—Wall Sensor
C6-3—Cliff Sensors
Charging Contact Areas
C7
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the docking station and the robot.