Roborock Q5 Mode D'emploi page 8

Zone 1 –
Cleaned
Zone 4 –
Next Zone
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
Spot Cleaning
Press and hold the button to start spot
cleaning.
Cleaning range: The robot cleans a 1.5 m (4.9 ft)
x 1.5 m (4.9 ft) square area centered on itself.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Pause
When the robot is running, press any button
to pause it, press the button to resume
cleaning, press the button to send it back
to the dock.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Sleep
Zone 2 –
Cleaned
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button to
wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
Zone 3 –
• The robot will automatically shut down if left in sleep mode for
In Progress
more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
Charging
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the
send the robot back to the dock. The power
indicator will pulse as the robot charges.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs, the power indicator
will flash red and a voice alert will sound.
See " Errors" for solutions.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
System Reset
If the robot does not respond when a button
is pressed or cannot be turned off, reset
the system. Press the Reset button, and the
robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot
will then be restored to factory settings.
App Features
button to
Cleaning Map
• Multi-Map Management
• Real-Time Vacuum Route
• Map Zoning
• Map Editing
Custom Cleaning Modes
• Scheduled
• Selective Room
• Zone
• No-Go Zones & Invisible Wall
08
button and at the same time press