Roborock Q5 Mode D'emploi page 10

Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged during
normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Environmental Protection
Description
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
How to remove the battery:
Note:
The following information applies only when disposing
of the robot or if the battery is no longer functioning normally.
You will be able to recognize this problem if, even when left to
charge, the robot cannot clean due to a low battery. Do not
remove the battery if you intend to continue using the robot.
1. Turn off the robot.
2. Unscrew the battery cover.
3. Remove the battery cover.
4. Press the clip to pull out the battery
connector.
5. Remove the battery.
Notes:
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the battery
pack casing to avoid short-circuits or leakage of hazardous
substances.
• In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
Basic Parameters
Robot
Model Q340RR
14.4V/5200mAh
Battery
lithium-ion battery
Approx. 3.2kg (7.05 lbs. )
Weight
Rated Input 20V
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Docking Station
Model SPCDZ01RR
Rated Input 20V
Rated Output 20V
10
Power Supply
Model
Rated Input
Rated output
Charging Battery
Errors
If an error occurs while the robot is cleaning, the
power indicator will flash red quickly, and a voice
alert will sound. Refer to the following table for
troubleshooting.
1. After resolving any of the following errors, relocate
your robot and restart cleaning.
2. After any sensor errors, clean the sensor and retry.
3. If the battery is at an abnormal temperature, wait
for it to return to normal before use.
Error 1:
1.2A
Error 2:
Error 3:
Error 4:
Error 5:
1.2A
Error 6:
1.2A
Error 7:
YJS024W-2001200U
100V–240 V~ 50/60 Hz, 0.8 A
20V 1.2A
14.4V/5200mAh
lithium-ion battery
LiDAR turret or laser blocked. Check
for obstruction and retry.
Bumper stuck. Clean it and lightly tap
to release it.
Wheels suspended. Move robot and
restart.
Cliff sensor error. Clean cliff sensors,
move robot away from drops and restart.
Main brush jammed. Clean main brush
and bearings.
Side brush jammed. Remove and clean
side brush.
Wheels jammed. Move the robot and
restart.