Roborock Q5 Mode D'emploi page 6

Product Overview
A
Robot (Top View)
A1
—Power/Clean
• Press and hold to turn the robot on or off
• Press to start cleaning
—Power Indicator
• White: Battery level ≥ 20%
• Red: Battery level < 20%
• Pulsing: Charging or starting up
• Flashing red: Error
—Dock/Spot Clean
• Press to return to dock
• Press and hold to start spot cleaning
—WiFi Indicator Light
• Flashing blue slowly: Waiting for
connection
• Flashing blue quickly: Connecting
• Steady blue for five seconds: WiFi
connected
Note: Press any button to stop the robot during cleaning or docking.
A1-1—Bumper
A1-2—LiDAR Sensor
A1-3—Vertical Bumper
A1-4—Dustbin
A1-5—Dock Locator
Robot (Bottom View)
A2
A2-1—Wall Sensor
A2-2—Cliff Sensors
A2-3—Omni-Directional Wheel
A2-4—Charging Contacts
A2-5—Side Brush
A2-6—Main Wheel
A2-7—Main Brush
A2-8—Main Brush Cover Latches
Robot (Dustbin Removed)
A3
A3-1—Air Inlets
A3-2—Reset Button
Dustbin
A4
A4-1—Air Inlets
A4-2—Dustbin Latches
A4-3—Washable Filter
A4-4—Filter Latch
Docking Station
A5
A5-1—Power Indicator
A5-2—Dock Location Beacon
A5-3—Charging Contacts
A5-4—Power Socket
A5-5—Electrode Brushes
Main Brush Cleaning Tool
A6
Power Supply
A7
06
Installation
B
Important Information
B1
B1-1—Tidy cables and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due
to items becoming tangled in, struck by,
or knocked over by the robot.
B1-2—When using the robot in a raised area,
always use a secure physical barrier to
prevent accidental falls that may result in
personal injury or property damage.
Note: When using the robot for the first time, follow it
throughout its whole cleaning route and watch for potential
problems. The robot will be able to clean by itself in future uses.
Position the docking station
B2
Keep the docking station on a level surface,
flat against a wall. Connect the power cable
to the docking station and tidy cables from
the floor. To ensure a better user experience
of the mobile app, place the docking station
in an area with good WiFi coverage.
B2-1 More than 0.5m (1.6ft)
B2-2 More than 1.5m (4.9ft)
Notes:
• Allow at least 0.5m (1.6ft) of clearance on each side, and
more than 1.5m (4.9ft) in front of the docking station.
• If the power cable hangs vertical to the ground, it may be
caught by the robot, causing the docking station to be
disconnected.
• The docking station indicator is on when the docking station
is electrified, and off when the robot is charging.