LORCH Handy 200 BasicPlus Manuel D'utilisation page 37

Starting up
14 .3 Call up the secondary parame-
ters (Handy 200 ControlPro)
 Press the Menu button 19 to call up the
secondary parameters.
 Select the desired secondary parameter
with the control knob 13.
9 The parameter code and the correspon-
ding setting are displayed alternately in
the 7-Segment display 20.
 Confirm the secondary parameter by
pressing the Menu button 19.
9 The set value flashes in the 7-segment
display 20.
 Use knob 13 to set the desired value.
 Save the set value by pressing the Menu
button 19.
‰ Change to the previous or next secondary
parameter with knob 13.
 Exit the secondary parameters by pres-
sing the Electrode/TIG button 18.
The following secondary parameters are
available.
Parameter
Start current
Start current
time
Hotstart
Hotstart time
10.15
Mode
5... 200
50 %
%
0,0...
0,1 s
20 s
125 5... 200
X
% %
0,0...
1,0 s X
20 s
Parameter
Arc dynamic
The welding current increases automatically
as the welding voltage is reduced. The arc
dynamic indicates the ratio between the
main current and the automatic increase.
Weld end
detection
(correction
value)
Your welding machine switches the welding
current off at a certain arc length. (Weld end
detection.) The maximum length of the arc can
be adapted using the „SEE" parameter.
Tab. 2: Secondary parameters
14 .4 Master reset
(Handy 200 ControlPro)
Warning! All personal settings
i
will be lost .
All welding and secondary para-
meters are reset to their factory
settings (master reset function).
 Press buttons 18 and 19 simultaneously
for at least 3 seconds
X
9 The 7 segment display and the control
panel indicators light up briefly as confir-
X
mation.
Mode
100 0... 200
X
% %
100 0... 200
X X
% %
- 37 -